True SPECTRUM ELLIPTICAL XS1000 Owner's Manual page 20

CHAPTER 2: ASSEMBLY GUIDE
ASSEMBLY STEPS:
STEP 10 Install Draw-Bars:
b) Slide each drawbar onto its shaft and
install and fully tighten M10 1.5x75mm
bolt, flat washer and M10 nut with a 17mm
socket and wrench.
c) Tighten the bottom 8 bolts with 6mm
allen wrench.
Hardware Required:
2 M10 x 75mm Bolts
2 M10 Nuts 2 Flat Washers
STEP 11 Install Pedal Tubes:
a) Use 2 M10 x 80 mm bolts and 2 M10 nuts
to attach the Pedal Tubes, but do not fully
tighten.
Hardware Required:
2 M10 x 80 mm bolts
2 M10 Nuts
b) Ensure that the Pedal Tubes are centered
on the crankshaft rollers.
c) Fully tighten the pedal tube bolts.
Truefitness.com / 800.426.6570 / 636.272.7100
20 of 36