True SPECTRUM ELLIPTICAL XS1000 Owner's Manual page 19

ASSEMBLY STEPS:
STEP 9 Install Chin-Bar Covers and Gasket:
a) Attach the inner and outer chin-bar
covers using 6 M5 0.8 x 12 mm screws
and 1 M5 0.8 x 50 mm screw.
*Screw locations shown on the right.
b) Slide the black rubber gaskets down
the pedestal uprights until they are snug
against the newly installed chin bar covers.
Hardware Required:
12 M5 0.8 x 12 mm bolts
2 M5 0.8 x 50 mm bolts
2 Flat Washers
*DO NOT use an impact drill when
assembling plastic components.
STEP 10 Install Draw-Bars:
a) Secure the bottom of each drawbar
using 4 M8x 12 bolts and 4 M8 curved
washers, but do not fully tighten.
Hardware Required:
8 M8 1.25 x 12 mm bolts
8 Curved Washers
CHAPTER 2: ASSEMBLY GUIDE
Short Screw
Truefitness.com / 800.426.6570 / 636.272.7100
Long Screw
& Washer
Short Screw
19 of 36