Assembly Steps - True SPECTRUM ELLIPTICAL XS1000 Owner's Manual

Hide thumbs Also See for SPECTRUM ELLIPTICAL XS1000:

Table of Contents

CHAPTER 2: ASSEMBLY GUIDE

ASSEMBLY STEPS:

Measure Doorways:

Measure all doorways, hallways and stairwells to make sure that the 34.5" frame can fit through them. If it will not fit,

move all parts to the final location and assemble machine in that location. If the machine needs to be placed on its

side, separate the upper pedestal from the base and keep the left side foam packaging attached to the base to help avoid

damaging the plastic covers as shown.

a) Disconnect the cables from the lower

Lower Board

Ground Cable

Coax Cable

board.

Network Cable

b) Separate the Network cable and

COAX cable at the base of the right

pedestal.

c) Disconnect the Ground cable on the

right pedestal hinge.

d) Remove the shoulder bolts on each

pedestal hinge and carefully remove the

Shoulder Bolts

pedestal from the elliptical base.

NOTE: The elliptical base can be set

on its LEFT side, but ONLY with the

attached foam packaging underneath it.

Truefitness.com / 800.426.6570 / 636.272.7100

14 of 36

Table of Contents