HP 8753E Programming And Command Reference Manual page 144

These commands output the power meter calibration array. Values
should be entered as 100 times the power meter reading in dB. A
default array is used if a power meter calibration sweep, TAKCS, has not
been taken:
These 4 commands output the pre-raw measurement data. Analogous
to OUTPRAW except that pre-raw data has not had sampler correction
nor attenuator offsets applied. These offsets are not necessary for data
that will be fully error corrected. See BASIC programming Example 2E:
arrays hold Sl 1, S2 1, S12, and S22, respectively:
HP-IB Progr amming and Command Reference Guide
Channel 1.
Channel 2.
Array 1 (Sll data).
Array 2 (S21 data).
Array 3 (S12 data).
Array 4 (S22 data).
Outputs a raster dump of the display,
intended for a graphics printer.
Outputs all of the List Values or Operating
Parameters in text mode. Activate the
desired function by preceding with LISV
or OPEP, respectively.