HP 8753E Programming And Command Reference Manual page 121

These 6 commands display the indicated combinations of data and trace
memory on the active channel:
l-l 14 HP-IB Progr amming and Command Reference Guide
Data only.
Data and memory.
Data divided by memory (linear division,
log subtraction).
Data minus memory (linear subtraction).
Memory only.
Same as DISPDDM.
Done with a class of standards, during a
calibration. Only needed when multiple
standards are measured to complete the
class.
Done modifying a test sequence.
Begins execution of the selected sequence.
Range: 1 to 6.
Decrements the value in the active entry
area (down key).
Dual channel display ON or OFF.
Duplicates sequence X to sequence Y.
Range X, I? 1 to 6.
Done editing list frequency or limit table.
Begins editing limit table.
Begins editing list frequency table.
Sets the electrical delay offset.
Sends out a beep during a sequence.
Turns the active entry area OFF.
Outputs event-status register B.