HP 8753E Programming And Command Reference Manual page 131

These 8 commands edit a limit test segment. The limit table editing is
begun with I
ED TL I ML
the table is closed with
HP-IB Programming and Command Reference Guide
Turns the display of the limit lines ON and
OFF.
Marker to limit offset. Centers the limit
lines about the current marker position
using the limit amplitude offset function.
Enters the stimulus offset of the limit
lines. Range: stimulus range.
Turns limit testing ON and OFF.
I
Sets the limit delta value while
editing a limit line segment.
Range: amplitude range.
Sets the lower limit value. Range:
amplitude range.
Sets the middle limit value. Range:
amplitude range.
Sets the limit stimulus break point. Range:
Makes the segment a flat line.
Makes the segment a sloping line.
Makes the segment a single point.
Sets the upper limit value. Range:
amplitude range.
Selects a linear frequency sweep.
Selects the linear magnitude display
format.
Enters the line type for plotting data.
Range: 0 to 10.
Enters the line type for plotting memory.
Range: 0 to 10.
Selects the list frequency sweep mode.