Sharp AR-M550N Operation Manual page 84

NORMAL COPYING
Select the desired output mode (page 4-9).
7
2-SIDED COPY
OUTPUT
FILE
screen, and then touch the [OK] key on the setting
screen.
8 Use the numeric keys to set the desired
number of copies.
entry if a mistake has been made.
9 If needed, touch the [FILE] key or the
[QUICK FILE] key.
FILE
QUICK FILE
For more information on this function, see
"Document filing function" in chapter 7.
If the [FILE] key is grayed out, only the [QUICK
FILE] key can be selected.
When you touch the [QUICK FILE] key, a
message asking you to confirm the save will
appear. Touch the [OK] key in the message
screen and go to the next step.
If you wish to cancel the save, touch the [QUICK
FILE] key after touching the [OK] key so that the
[QUICK FILE] key is no longer highlighted.
4-8
The sort mode is the
default mode.
To select the group
mode, touch the
[OUTPUT] key, then
touch the [GROUP] key
on the output setting
Up to 999 can be set.
If you are only making a
single copy, the copy
can be made with the
copy number display
showing "0". Use the [C]
(clear) key to cancel an
Either key can be
touched to store the
scanned document
image on the machine's
hard disk. The stored
image can be re-used
later.
Press the [START] key.
10
progress is output to the original exit area. In these
cases the copy quantity will be reset to "0".
NOTES
G The 1-sided to 1-sided copying mode is set as the
default in the initial settings. If the default setting
has not been changed using the "Initial status
settings" program (key operator program), steps 3
to 5 on page 4-7 can be omitted.
To cancel copying...
To cancel a copy job in progress, press the [CA]
key. A confirmation message will appear. Touch
the [YES] key to cancel copying.
If the [C] key is pressed
while originals are being
scanned, scanning will
stop. If copying had
already started, copying
and scanning will stop
after the original in