Sharp AR-M550N Operation Manual page 66

FINISHER AND SADDLE STITCH FINISHER
I I I I Removing a staple jam in the saddle stitch finisher
1 Perform steps 1 to 3 of the procedure for
"Replacing the cartridge in the saddle
stitch finisher" on page 3-8.
2 Remove the empty staple case.
3 While pushing down on lever
knob .
(B)
(A)
(B)
Remove any jammed staples, and then
4
return knob to its original position.
(B)
(B)
Jammed staples
NOTE
Do not touch the stapling area.
The stapler could injure you.
I I I I Disposal of hole punch scrap (when the punch module is installed)
Open the cover of the hole punch module.
1
3-10
, pull up
(A)
Be sure to remove any
strips of staples.
Return the staple case to its original
5
position.
Return the saddle stitch holder and the
6
saddle stitch unit to their respective
original positions.
7 Make sure that the finisher is firmly
attached to the machine and that 11" x 17",
8-1/2" x 11"R, or 8-1/2" x 14" (A3, A4R, or
B4) size paper is loaded.
If one of the above paper sizes is not set, test
stapling cannot be performed.
8 Close the lower cover of the finisher.
Test stapling is automatically performed on a
blank sheet.
This operation is carried out to avoid blank
stapling.
NOTE
If test stapling fails to take place, repeat steps 1 to 7.
Holding the black handle, slide out the
2
case containing the paper bits, and
dispose of them properly.
Return the waste case to its original
3
position.
4 Close the cover of the hole punch module.