Placing Originals - Sharp AR-M550N Operation Manual

PLACING ORIGINALS

I I I I Using
the automatic
feeder
Open the document cover, make sure that
1
an original has not been left on the
document glass, and then gently close the
document cover.
2 Adjust the original guides to the size of the
originals.
3 Place the originals face up in the
document feeder tray.
line (maximum of 150 pages).
NOTE
Original size detection function
One of the four groups of standard original sizes shown below can be selected for detection by the original size
detection function. The factory default setting is "INCH-1". The setting can be changed using "ORIGINAL SIZE
DETECTOR SETTING" in the key operator programs.
Group
1 INCH-1
2 INCH-2
3 AB-1
4 AB-2
document
Place the originals face
up.
Insert the originals all
the way into the
document feeder. The
stack height must not be
higher than the indicator
Detectable original sizes
Document feeder tray (for reversing automatic document feeding)
Document glass
11" x 17", 8-1/2" x 14", 8-1/2" x 11",
8-1/2" x 11"R, 5-1/2" x 8-1/2"
11" x 17", 8-1/2" x 13", 8-1/2" x 11",
8-1/2" x 11"R, 5-1/2" x 8-1/2"
A3, A4, A4R, A5,B4, B5, B5R
A3, A4, A4R, A5,B5, B5R, 216x330
I I I I Using the document glass
Open the document cover, place the
original face down on the document glass,
and then gently close the document cover.
NOTE
Do not place any objects under the original size
detector, because they may damage it or the original
size may not be detected properly.
Document glass scale
mark
8½x14
or B4
8½x11 or A4 11x17 or A3
GAlign the corner of the original with the tip of the
arrow mark on the document glass scale.
GPlace the original in the appropriate position for its
size as shown above.
Document glass + A4
Document glass + A4
Document glass + 8-1/2" x 11", 216x330
Document glass + 8-1/2" x 11", B4
Document glass scale
mark
8½x11
or A4
4-3
4