Delta Electronics PCI-M324 User Manual page 68

PCI-M324 User Guide
No.
(10)
(11)
After opening the main screen, you need to set the relevant settings before executing motion
control.

Open the I/O related setting screen to set the signal logic, including ALM, INP, ELL, ORG, etc.
Click Interface I/O Configuration (Figure 6.4.3) on the M324 main screen to open the I/O
related setting screen (Figure 6.4.4).
November, 2017
Item
Moving Mode
A Move Reference
Description

Check [Repeat] to repeatedly execute clockwise and
counterclockwise motions.

Check [S Curve] to set S-Curve acceleration /
deceleration; otherwise, T-Curve is used.

Check [Abs] to use absolute motion; otherwise, relative
motion is used.
Command: absolute motion follows the command counter.
Encoder: absolute motion follows the feedback counter
position.
Figure 6.4.3
Figure 6.4.4
EzDMC Functions
6
6-5