Table of Contents
Advertisement
1
2
3
NOTE
4
Chapter 1 How to Begin
Assembling the TIA
Assembling the TIA
HP E1725C TIA Assembly
This section assumes that the HP E1725C is completely disassembled.
Just skip the steps that do not apply to your situation. The intention is to
meet your needs if in the future you need to rebuild an HP E1725C that
has been disassembled. The standard HP E1725C is shipped from the
factory assembled and configured.
Before you start, make sure power is shut off to all of the components.
Install the HP E1406A Command Module in slot 0 of the VXI mainframe.
(With the standard HP E1725C 6-slot mainframe, this will be the slot at
the bottom or left side, depending on the orientation of the mainframe.)
Line up the module with the slot guides and then press the module firmly
into the backplane connectors. Tighten the screws attached to the
command module to fully seat the module into the backplane connectors of
the mainframe.
Install the HP E1740A TIA module in slots 1 and 2 of the VXI mainframe
or any other open slots.
Always check that the mainframe power is OFF before installing any
boards or instruments into the backplane connectors. This is also a good
time to check that the TIA module address setting is unique and different
from other modules already installed in the mainframe. The HP E1740A
address (ULA) is set to 48 at the factory, corresponding to a secondary
address of 06 when using the HP 82335A/B HP-IB Interface Card. If you
are installing multiple TIAs, make sure each one has its own unique
address. See the HP E1740A TIA User's Guide for more information about
address switch settings.
Line up the module with the slot guides and then press the module firmly
into the backplane connectors. Use the screws attached to the module to
securely tighten down the module.
Getting Started Guide
1-5
Advertisement
Table of Contents
