Table of Contents
Advertisement
Before You Can
Use the External
Analyzer
Assembling the
Analyzer Probe
4-2 Using the External Analyzer
There are several things to do before you can use the external analyzer;
these things are listed below and explained in the following paragraphs.
Assemble the analyzer probe.
Connect the probe to the emulator.
Connect the probe wires to the target system.
Specify the threshold voltages for the external probe signals.
Label the external trace signals.
Select the external analyzer mode.
The analyzer probe is a two-piece assembly, consisting of ribbon cable
and 18 probe wires (16 data channels and the J and K clock inputs)
attached to a connector. Either end of the ribbon cable may be
connected to the 18 wire connector, and the connectors are keyed so
they may only be attached one way. Align the key of the ribbon cable
connector with the slot in the 18 wire connector, and firmly press the
connectors together. (See figure 4-1.)
Advertisement
Table of Contents
