Tia Tutorial; Presetting The Instrument To A Known State - HP E1725C Getting Started Manual

Chapter 2 Practice Using the TIA

TIA Tutorial

TIA Tutorial
You should already have the HP E1742A/43A/44/46A/48A application
running. If not, refer to Chapter 1 of this guide for information on how to
install the software and start the TIA application.
NOTE The windows and dialog boxes shown in this guide are those of the
HP E1742A. The screens on the HP E1743A/44A/46A/48A may have a
slightly different appearance.

Presetting the Instrument to a Known State

1 Once the TIA application is started, select File>Load Default Setup.
The default setup will configure the TIA to a known state as determined
by a set of parameters fixed at the factory, similar to the "preset" key on
many instruments.
You may also customize the initial user-interface configuration by first
configuring the instrument as desired and saving the setup in the file
"INISETUP.STP" (File>Save Setup (inisetup.stp)). This configuration
will automatically be loaded when the Windows application is started. In
general, instrument setups are saved by selecting File>Save Setup As.
Note that the INISETUP.STP file and the default parameters are two
different files, and may not necessarily result in the same instrument
configuration.
Getting Started Guide 2-5