Chapter 1 How to Begin
Installing the HP E1742A/43A/44A/46A/48A Analysis Software
Installing the HP E1742A/43A/44A/46A/48A
Analysis Software
This section provides instructions for installing the user-interface
software onto your computer. This software is already installed on the
HP E1725C TIA. If you have purchased the HP E1742A/43A/44A/46A/48A
Analysis Software by itself, follow these instructions to install the
software.
HP E1725C TIA Requirements
The following are the minimum requirements to support operation of the
HP E1725C TIA using the HP E1742A/43A/44A/46A/48A software.
•
20 MHz 386-based PC with a 387 co-processor
•
8 megabytes of RAM
•
A hard disk with at least 6 megabytes of free disk space
•
DOS version 5.0 (or later) and Microsoft Windows
®
Windows
95)
•
A two-button mouse
It is recommended that you always read any "readme" files associated
with the software before proceeding with the installation. These files
contain important information which may not be found elsewhere.
The HP E174XA readme file can be viewed by one of the following
methods:
•
Insert the HP E174XA disk 1 in drive a: (or whatever floppy drive is
appropriate). Start Windows 95, select Programs group, double-click
on Windows Explorer icon, choose drive a:, and double-click on the
"readme.wri" file.
•
If the HP E174XA software is already installed on the PC, double-click
on the "readme" icon in the HP Applications program group.
Getting Started Guide
®
version 3.1 (or
1-7