Iris Display - Panasonic AK-UCU600P Operating Instructions Manual

IRIS display

When the information is not displayed on the picture monitor, display it by pressing the [CHARA] button of the ROP.
A. Camera number
B. IRIS F value
C. IRIS level
D. IRIS memory
E. TALLY INFO
● Set each item to be displayed on the [PM VIEW SETTING] screen that can be accessed by selecting [MAINTENANCE] on the
CCU menu. However, this screen will not appear if the menu's [IRIS LEVEL] setting is [OFF].
● The IRIS schedule is displayed as follows depending on the setting of [IRIS SCALE] that can be accessed by selecting
[MAINTENANCE] > [SETUP].
IRIS SCALE: FULL
IRIS SCALE: 2STOP
• In the IRIS level display, the IRIS F value stored in IRIS memory is indicated at the center (+), and the current IRIS F value
is displayed relative to the center as " ".
When the center value (+) and the current IRIS value ( ) overlap, the display shows "
• When the IRIS level falls outside either end of the display range, the status is displayed as a flashing " " or " ".
● TALLY INFO (E)
• Display the R tally in two segments of the upper row and the R, G, or YL tally in two segments of the lower row.
• When all R, G, and YL tally signals are ON, the upper row is red, and the left and right segments of the lower row are
green and yellow, respectively.
• When the R and G tally signals are ON, the upper row is red and the lower row is green.
E
A
C 1
D
M EM: F5.6
-- ----- --+---- --- ---
E
C---------+--- --- ---O
C :C LO SE O:OPEN
- --------
- ---------+---- ---- -
- 30 -
E
F4 .8
C E
F4 .8
F4. 8
--- ---- --
F4. 8
Picture monitor (PM)
B
".