Rear Panel 2 - Panasonic AK-UCU600P Operating Instructions Manual

Rear panel 2

1 2
1 [LAN] connector
2 [AUX] connector
3 [TRUNK] connector
4 [COMMUNICATION] connector
5 [ROP] connector
6 [MSU] connector
7 [MIC1] and [MIC2] connectors
8 [CAMERA] connector
9 Cooling fan
10 AC power socket
11 [SIGNAL GND] terminal
3 4 5 6
It is the LAN connector (RJ45) for connecting the ROP (AK-HRP1000 / AK-HRP1005) with an IP
connection.
Use a switch hub and connect the devices with a 10BASE-T/100BASE-TX straight cable. This
connector is for connecting a personal computer when configuring Web settings.
"Web Screen" (see page 90)
This connector is used for controlling a waveform monitor and external systems (down-convert
system, MIC gain selection, alarm output, or tally output).
This connector provides two systems for 2-way communication of camera trunk data (RS-422
and RS-232C).
This connector is for connecting the intercom signals and tally signals to the external system.
This connector is for connecting a ROP (sold separately).
This connector is for connecting an MSU (sold separately).
These connectors are for outputting the analog signals of microphones 1 and 2 of the camera.
The microphone level is 0 dBm/600 Ω.
This connector is for connecting the optical fiber multi cable (sold separately).
This is the unit's cooling fan.
This socket is for inputting AC power.
Connect the supplied power cable, and use a 3-prong outlet and ground the unit properly.
Connect this to the system ground.
- 26 -
7 8
9
Parts and their functions
10
11