Information Display - Panasonic AK-UCU600P Operating Instructions Manual

Information display

This information is displayed on the picture monitor (PM).
Warning displays
The warning information is displayed when trouble is detected in the unit, camera, or optical fiber multi cable.
● Warning information displayed is cleared when the status returns to normal.
● To manually clear the warning information display, hold down the [CHARA] button of the ROP.
Information displayed
Display item
CAM RCV LVL NG
CCU RCV LVL NG
CAM FAN NG
CCU FAN NG
CAM HIGH TEMP
CCU HIGH TEMP
CAM OVER TEMP
OVER LOAD
POWER CONT ERROR
CABLE OPEN
CABLE SHORT
FORMAT NG
During data transfer (CAM←→ROP)
- WARNING -
CAM RCV LV L N G
CCU RCV LV L N G
The level of the optical signal received by the camera is low
The level of the optical signal received by the CCU is low
Trouble with the cooling fan of the camera
Trouble with the cooling fan of the CCU
The temperature of the camera is abnormally high
The temperature of the CCU is abnormally high
If you continue operation even with the message displayed, power supply to the camera may
stop as a protective measure.
Due to overheating, the camera turned OFF automatically as a protective measure
The power supply circuit load to the camera exceeded 90%
Trouble with the power supply circuit to the camera
The optical fiber multi cable is not connected
● The optical fiber multi cable is shorted
● The power supply voltage to the unit dropped momentarily
Power supply to the camera will stop as a protective measure.
Turn the unit off immediately, and determine and resolve the problem before turning it back
on.
● The camera is malfunctioning or startup of the camera failed for reasons other than the
above.
The CAM mode and CCU mode do not match.
Data transfer between the camera and ROP is in progress.
- 29 -
Description
Picture monitor (PM)