Connect The Router To A Console Device - Juniper ACX5448 Quick Start Manual

ACX5448 Universal Metro Router Quick Start Guide

Connect the Router to a Console Device

To use a system console to configure and manage the router, connect it to the appropriate
port is used to connect a laptop or console terminal to configure the router (see
a cable with an RJ-45 connector. One serial cable with an RJ-45 connector and a DB-9 connector is provided with the router.
NOTE: Use shielded CAT5e cable for connecting the
To connect a management console:
Turn off power to the console device.
1.
Plug the RJ-45 end of the serial cable (see
2.
Plug the female DB-9 end into the device's serial port.
3.
NOTE:
For console devices, configure the serial port as follows:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 20: Connecting the Router to a Management Console Through a Console Server
CON
To Console
port
Figure 21: Connecting the Router Directly to a Management Console
Table 5 describes the console port for the ACX5448 router.
Table 5: Console Port on the ACX5448 Router
Label
CON
14
Figure 19) into the
Console server
Callout
4
(See Figure 1.)
Figure 20 and
and ports on the router.
CON MGMT
port on the router.
CON
PC
Description
Connect a laptop or console terminal to configure
the router.
CON port on the router. The console
Figure 21). The console port accepts
Copyright © 2018, Juniper Networks, Inc.