Configuring Ntp-Ptp Interworking - Cisco ASR 9000 Series User Configuration Manual

Configuring NTP-PTP Interworking

Command or Action
Configuring NTP-PTP Interworking
Use this task to configure NTP to use PTP as the time source.
Before You Begin
PTP must be supported and enabled on the router before NTP-PTP interworking can be configured. If PTP
is not enabled, you receive an error message similar to the following when you try to commit the configuration:
RP/0/RSP0/CPU0:router(config)# ntp master primary-reference-clock
RP/0/RSP0/CPU0:router(config)# commit
% Failed to commit one or more configuration items. Please issue
'show configuration failed' from this session to view the errors
RP/0/RSP0/CPU0:router(config)# show configuration failed
[:::]
ntp
master primary-reference-clock
!!% 'ip-ntp' detected the 'fatal' condition 'PTP is not supported on this platform'
!
end
Refer to the
SUMMARY STEPS
1. configure
2. ntp
3. master primary-reference-clock
4. Use one of the following commands:
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 ntp
Example:
RP/0/RSP0/CPU0:router(config)# ntp
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
222
Purpose
Configuring PTP , on page 233
• end
• commit
module for more information.
Purpose
Enters NTP configuration mode.
Implementing NTP