Enabling Call Home - Cisco ASR 9000 Series User Configuration Manual

Enabling Call Home

Enabling Call Home
By default the sending of Call Home messages is disabled. You must perform this task to enable the sending
of Call Home messages.
Before You Begin
Before enabling the sending of Call Home messages, you should complete the configuration tasks described
in this module. Specifically, you must have enabled a destination profile for any Call Home messages to be
sent.
SUMMARY STEPS
1. configure
2. call-home
3. service active
4. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
call-home
Example:
RP/0/RSP0/CPU0:router(config)# call-home
RP/0/RSP0/CPU0:router(config-call-home)#
Step 3
service active
Example:
RP/0/RSP0/CPU0:router(config-call-home)# service active
Step 4 commit
Configuring Smart Call Home (single command)
SUMMARY STEPS
1. configure
2. call-home reporting { anonymous | contact-email email-address } [ http-proxy { address } port
port-number ]
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
320
Configuring Call Home
Purpose
Enters call home configuration mode.
Enables the sending of Call Home messages.