Enabling Tls - Cisco ASR 9000 Series User Configuration Manual

Implementing Open Flow Agent
Command or Action
Example:
RP/0/RSP0/CPU0:router (config-openflow) #
bridge-group SDN-1 bridge-domain of2
Step 7 controller ipv4 ip-address security [tls | none]
Example:
RP/0/RSP0/CPU0:router(config-openflow-switch)#
controller ipv4 5.0.1.1 port 6633 security tls
Step 8
commit
Example:
RP/0/RSP0/CPU0:router(logical-switch)# commit
Step 9
commit
What to Do Next
Repeat these steps to configure another logical switch for the OpenFlow Agent.

Enabling TLS

SUMMARY STEPS
1. configure
2. openflow switch logical-switch-id
3. tls trust-point local local-tp-name remote remote-tp-name
4. commit
5. end
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 openflow switch logical-switch-id
Example:
RP/0/RSP0/CPU0:router(config)# openflow switch 100
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
Purpose
Configures the Openflow controller for the logical switch.
Configures the Openflow controller for the logical switch.
Once the controller command is entered, a connection to
the OpenFlow controller is started for the logical switch.
Note The OpenFlow Agent can connect to a single
Controller or up to 8 Controllers. Repeat this step
if you need to configure additional Controllers.
Adds the Layer 2 logical switch configuration for the
OpenFlow agent to the running configuration.
Purpose
Enters the OpenFlow logical switch configuration
mode.
Enabling TLS
293