Cisco ASR 9000 Series User Configuration Manual page 337

Configuring Call Home
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 call-home
Example:
RP/0/RSP0/CPU0:router(config)# call-home
RP/0/RSP0/CPU0:router(config-call-home)#
Step 3 sender from email-address
Example:
RP/0/RSP0/CPU0:router(config-call-home)# sender
from
my_email@cisco.com
Step 4 sender reply-to email-address
Example:
RP/0/RSP0/CPU0:router(config-call-home)# sender
reply-to
my_email@cisco.com
Step 5 mail-server address priority priority
Example:
RP/0/RSP0/CPU0:router(config-call-home)#
mail-server
198.51.100.10 priority 1
Step 6
rate-limit events-count
Example:
RP/0/RSP0/CPU0:router(config-call-home)#
rate-limit 4
Step 7 commit
Step 8 show call-home mail-server status
Example:
RP/0/RSP0/CPU0:router# show call-home mail-server
status
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
Purpose
Enters call home configuration mode.
(Optional)
Specifies the email message "from" address.
(Optional)
Specifies the email message "reply-to" address.
Specifies the mail server to use to send Call Home
messages. You can specify an IP address or mail server
name. You can specify up to five mail servers to use.
The server with the lower priority is tried first.
Specifies the maximum trigger rate per minute. The
default is five events per minute and the maximum is
also five.
Displays the status of the specified mail server.
Configuring Email
319