Displaying System Hardware Version Information - Cisco ASR 9000 Series User Configuration Manual

Managing the Router Hardware

Displaying System Hardware Version Information

To display hardware version information for all or some of the components assigned in a system, connect to
the designated shelf controller (DSC) and enter the show diag command in administration EXEC mode.
When this command is entered in administration EXEC mode, you can display information on RSPs, line
cards, and system components such as the chassis, fan trays, and power supplies.
Note If you enter the show diag command in EXEC mode, the software displays only the hardware assigned
to the SDR to which you are connected.
The syntax for the show diag command in administration EXEC mode is:
show diag [node-id | chassis | details | fans | memory | power-supply | summary]
For information on the software version, use the show version command.
Tip
In the following example, the show diag command displays information for all nodes in the system:
RP/0/RSP0/CPU0:router(admin)# show diag
Mon Jun 29 01:21:04.571 PST
NODE module 0/RSP0/CPU0 :
MAIN:
S/N:
Top Assy. Number:
PID:
UDI_VID:
HwRev: V4.8
New Deviation Number: 0
CLEI:
Board State : IOS XR RUN
PLD:
MONLIB: QNXFFS Monlib Version 3.2
ROMMON: Version 1.0(20081208:173612) [ASR9K ROMMON]
Board FPGA/CPLD/ASIC Hardware Revision:
NODE fantray 0/FT0/SP :
MAIN:
S/N:
board type 0x100302
FOC1230803H
68-3160-04
A2K-RSP-4G-HDD=
VP4
IPUCARJBAA
Motherboard: N/A, Processor: 0x8004 (rev: 2.2), Power: N/A
Compact Flash : V1.0
XbarSwitch0 : V1.3
XbarSwitch1 : V1.3
XbarArbiter : V1.0
XbarInterface : V0.0
IntCtrl : V1.14
ClkCtrl : V1.13
PuntFPGA : V1.5
HD : V3.0
USB0 : V77.20
USB1 : V77.20
CPUCtrl : V1.17
UTI : V1.6
LIU : V1.0
MLANSwitch : V0.0
EOBCSwitch : V2.0
CBC (active partition)
CBC (inactive partition)
board type 0x900211
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
Displaying System Hardware Version Information
: v1.2
: v1.1
103