Reloading The Active Rsp - Cisco ASR 9000 Series User Configuration Manual

Reloading the Active RSP

Table 18: Commands to Reload, Shut Down, or Power Cycle a Node, on page 120
described in this section.
Table 18: Commands to Reload, Shut Down, or Power Cycle a Node
Command
hw-module location node-id power disable
hw-module location node-id reload
hw-module shutdown location node-id
Reloading the Active RSP
The reload command causes the active RSP to reload the Cisco IOS XR software according to the
configuration register setting. This setting determines how the active RSP acts when reloaded.
This section contains instructions to reload the Cisco IOS XR software and return to EXEC mode. For
instructions to use the reload command for entering ROM Monitor bootstrap mode, see Cisco ASR 9000
Series Aggregation Services Router ROM Monitor Guide.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
120
Managing the Router Hardware
summarizes the commands
Description
This command administratively turns the power off
for a node. It is entered in administration
configuration mode. The changes do not take effect
until you enter the commit command.
To power on a node, use the no form of this
command.
Note This command cannot be used to disable
power on the RSP from which the command
is entered.
This command works in EXEC mode and reloads the
Cisco IOS XR software on a specific node or all
nodes. To specify all nodes, enter the all keyword
in place of the node-id argument. The node reloads
with the current running configuration and active
software set for that node.
This command must be entered in administration
configuration mode and administratively shuts down
the specified node. Nodes that are shut down still have
power but cannot load or operate Cisco IOS XR
software.
To return a node to the up state, use the no form of
this command.
This command cannot be used to shut down
Note
the RSP from which the command is entered.