Table of Contents
Advertisement
DIGITAL VIDEO RECORDER
GB
Rear View
1
2
3
No
Name
RS232 PORT
1
2
RS485 PORT
3
VIDEO IN/OUT
4
AUDIO IN/OUT
LAN
5
6
MODE
SCSI
7
1-5
4
5
6
7
8
9
10
Function
Serial Port for remote control.
Serial Port for remote control.
Composite image signal I/O terminal (BNC Style Connector).
Audio Signal Input/Output Jacks (RCA Jacks).
LAN Cable Connection Terminal.
It is the DIP switch to set System ID, Direct Communication,
Termination, etc.
1~5 : System ID.
G
G
6
: Not Use.
G
7
: Termination On/Off (Of all the directly connected
systems, it sets the last system as On).
8
: Not Use.
G
SCSI Connector for Data Backup
11
No
8
9
10
11
Name
Function
EXTERNAL I/O
G
ALARM IN: In the N.C. (Normally Closed) mode, the system
recognizes an alarm when a High (5V) signal is input for over
PORT
0.5 seconds. In the N.O. (Normally Open) mode, the system
recognizes an alarm when a Low (0V) signal is input for over
0.5 seconds. (Please refer to
"➁ ALARM DETECT TYPE"
on p. 3-18.)
ALARM RESET: The alarm mode is cleared when a Low (0V)
G
signal is input for over 0.5 seconds.
ALARM OUT: A High (5V) signal is output during alarm
G
recording.
TRIGGER OUT: This signal is for switching the recording
G
output screen of the Multiplexer.
G
REC IN: The system begins recording when a Low (0V) signal
is input for over 0.5 seconds.
G
DISK END: If the DISK END MODE of the RECORD
MODE SETUP is set to STOP, a Low (0V) signal is output for
about 1 second when the HDD becomes full during recording.
(Please refer to "➃ DISK END MODE" on p. 3-16.)
Fan
FAN
AC IN
Connects power cable.
POWER
Power On/Off button.
GB
1-6
Advertisement
Table of Contents
