Table of Contents
Advertisement
DIGITAL VIDEO RECORDER
GB
2
Q & A
Question
• Does recording continues after power cut
during recording.
• What would become of the system if
disconnected with the input image signal
during recording?
• What shall I do to stop recording manually
while the system is detecting movements or
in recording mode as set by the alarm.
• When system is in Reservation Recording
state, how to stop the recording
intentionally?
• What am I supposed to do if I forget the
system password or network ID and
password?
• May I use an itentical IP Address for more
than 2 systems?
7-3
Answer
– Without power supply, the system can't perform
recording. But if the system was recording before
power cut, it will resume recording upon power
supply.
– Without connection with the input image signal, the
system can't keep recording. But the system will
resume recording upon the supply of normal input
image signal.
– Press the STOP button (
) for 3 seconds.
Then, recording will be paused for 5 seconds and
you shall enter the menu to change the recording
setup in the meantime. If you want to stop the alarm
recording, you shall set the ALARM ENABLE of
the ALARM RECORD SETUP menu to OFF. If you
want to stop the reserved recording, you shall set the
TIMER of the ALARM RECORD SETUP menu to
OFF. Without your action against the system for 5
seconds, the system will return to the previous
mode.
– You should turn the power on and off while holding
on to the STOP button(
).
Then, the system setting value will be initialized as
it had just before factory shipment.
– Yes, but as long as the 2 systems are not connected
to LAN simultaneously. Connecting the system to
LAN one by one is to be connected to the remote
monitoring program by PC. If you want to connect
the other system to LAN to be connected to the
remote monitoring system by PC, you shall
disconnect the system currently connected to LAN
from the remote monitoring system by PC and
connect the system to LAN. Then resume
connection in at least one minute. Otherwise, you
may not be connected.
Advertisement
Table of Contents
