Removing The Msr (Magnetic Stripe Reader) - HP Engage One Retail System 141 Maintenance And Service Manual

Removing the MSR (Magnetic Stripe Reader)

The MSR consists of two main components that are connected together into one assembly.
To remove the MSR assembly:
1. Prepare the computer for disassembly
2. Remove the computer head unit from the stand
the stand on page
3. Remove the display panel from the computer head unit
4. Remove the top screw (1) and bracket (2), and then remove the bottom Phillips screw (3) and bracket (4)
from the reader.
5. Disconnect the MSR board cable from the system board (1).
TIP: Take extra care when disconnecting the cable. Pulling on the cable prematurely, before it is
disconnected, could cause damage to the connector.
6. Remove the Phillips screw (2) from the MSR board.
(Preparation for disassembly on page
27).
(Removing and attaching the Engage One head unit to
(Removing the display panel on page
Removing the MSR (Magnetic Stripe Reader)
19).
41)
55