Removing And Installing An M.2 Solid-State Drive (Ssd) - HP Engage One Retail System 141 Maintenance And Service Manual

Removing and installing an M.2 solid-state drive (SSD)

IMPORTANT:
transfer the data to the new SSD.
To remove and install an M.2 storage device:
1. Prepare the computer for disassembly
2. Remove the computer head unit from the stand
the stand on page
3. Remove the display panel from the computer head unit
4. To remove an SSD, remove the screw that secures the SSD to the system board (1), and then slide the
SSD out of the system board connector (2).
5. To install an SSD, slide the connector end of the SSD into the system board connector (1), and then
secure the other end of the SSD to the system board with the screw (2).
48 Chapter 4 Removal and replacement procedures
If you are replacing an SSD , be sure to back up the data from the old SSD so that you can
27).
(Preparation for disassembly on page
(Removing and attaching the Engage One head unit to
(Removing the display panel on page
19).
41)