Attaching An Optional Fingerprint Reader To The I/O Connectivity Base - HP Engage One Retail System 141 Maintenance And Service Manual

3. Connect the fingerprint reader USB cable to a USB Type-A port on the I/O connectivity base.
4. Reconnect the I/O connectivity base and computer power cords.
Attaching an optional fingerprint reader to the I/O connectivity
base
The optional fingerprint reader can be used as a standalone device or it can be attached to the I/O
connectivity base. Follow the procedure below to attach the fingerprint reader to the I/O connectivity base.
NOTE: You can attach the fingerprint reader to either side of the I/O connectivity base, but if you attach it to
the left side of the I/O connectivity base, the fingerprint reader will cover the microSD slot and the headset
jack on the I/O connectivity base.
1. Prepare the computer for disassembly
2. Place the fingerprint reader (1) on the riser (2), and then attach the mounting bracket (3) and cable
routing clip (4) to the fingerprint reader and riser with the two long screws (5) included with the
fingerprint reader.
(Preparation for disassembly on page

Attaching an optional fingerprint reader to the I/O connectivity base

19).
25