Removing The Power Button Board - HP Engage One Retail System 141 Maintenance And Service Manual

Removing the power button board

The power button board is secured with one Phillips screws.
To remove the power button board:
1. Prepare the computer for disassembly
2. Remove the computer head unit from the stand
the stand on page
3. Remove the display panel from the computer head unit
4. Disconnect the cable from the system board ZIF connector (1), and then lift the cable up to disengage it
from the adhesive that secures the cable to the system board.
5. Remove the Phillips screw (2).
6. Lift the power button board out of the computer head unit (3).
To reinstall the power button board, reverse the removal procedure.
54 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
27).
(Removing and attaching the Engage One head unit to
(Removing the display panel on page
19).
41)