Removing The Wlan Module - HP Engage One Retail System 141 Maintenance And Service Manual

Removing the WLAN module

Description
802.11 a/b/g/n + Bluetooth 4.0, 2x2
802.11 a/b/g/n + Bluetooth 4.0, 2x2 (for use only in Indonesia)
Intel Dual Band Wireless-AC 8260
The WLAN module is secured with one screw and has two connected antennas.
To remove the WLAN module:
1. Prepare the computer for disassembly
2. Remove the computer head unit from the stand
the stand on page
3. Remove the display panel from the computer head unit
4. To remove a WLAN module, disconnect the WLAN cables (1), remove the screw (2) that secures the
module to the system board, and then slide the module out of the system board connector (3).
IMPORTANT:
numbered labels on the WLAN module with the numbered labels on the cables when reconnecting the
cables.
(Preparation for disassembly on page
27).
The WLAN cables and connectors are labeled 1 and 2. Make sure that you match the
(Removing and attaching the Engage One head unit to
(Removing the display panel on page
19)
41)
Removing the WLAN module 49