Attaching An I/O Connectivity Base To The Engage One - HP Engage One Retail System 141 Maintenance And Service Manual

Attaching an I/O connectivity base to the Engage One

You can attach an I/O connectivity base to the bottom of the computer's stand.
1. Prepare the computer for disassembly
2. Remove the cover on the I/O connectivity base by removing the four screws on the underside of the I/O
connectivity base (1), and then lifting the cover off the I/O connectivity base (2).
3. Connect the USB Type-C power cable to the USB Type-C port on the underside of the stand's column.
20 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page 19).