Connecting A Standalone Optional Fingerprint Reader To The I/O Connectivity Base - HP Engage One Retail System 141 Maintenance And Service Manual

4. Place the bottom plate onto the I/O connectivity base (1), and then secure the plate to the I/O
connectivity base with the five screws (2).
5. Reconnect the I/O connectivity base's power cord and peripheral devices.
Connecting a standalone optional fingerprint reader to the I/O
connectivity base
The optional fingerprint reader can be used as a standalone device or it can be attached to the I/O
connectivity base. Follow the procedure below to connect a standalone fingerprint reader to the I/O
connectivity base.
1. Prepare the computer for disassembly
2. Connect the USB cable to the fingerprint reader (1) and route the cable through the routing channel (2)
on the fingerprint reader.
24 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page 19).