Mounting The Engage One Head Unit To A Wall - HP Engage One Retail System 141 Maintenance And Service Manual

Mounting the Engage One head unit to a wall

You can use an optional VESA mounting bracket to mount the computer head unit to a wall.
Screws sizes are 241-I052-M004 for the security screw and 241-I042-M059 for the VESA mount screw.
1. Prepare the computer for disassembly
2. Remove the computer head unit from the stand (if necessary)
head unit to the stand on page
3. Attach the VESA mounting bracket to a wall.
4. Connect the USB Type-C power cable to the USB Type-C port on the VESA mounting bracket (1). Align the
guide posts on the rear of the computer head unit with the corresponding holes in the VESA mounting
bracket, and then press the head unit onto the VESA mounting bracket (2).
You also have the option of routing the USB Type-C cable out the rear of the VESA bracket and through a
wall instead of attaching a USB Type-C cable to the port on the side of the bracket.
a. Press the rear cover release tab (1) on the VESA bracket, and then pull the rear cover off the VESA
bracket (2). Unplug the cable from the inside of the VESA bracket.
28 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
27).
19).
(Removing and attaching the Engage One