Diffserv Show Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
policymapname
Default
The default is None.
Command Mode
•
Global Config
•
Interface Config

DiffServ Show Commands

Use the DiffServ show commands to display configuration and status information for classes, policies,
and services. You can display DiffServ information in summary or detailed formats. The status information
is only shown when the DiffServ administrative mode is enabled.
12-58 show class-map
This command displays all configuration information for the specified class. The class-name is the name
of an existing DiffServ class.
show class-map class-name
Parameters
class-name
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Display Parameters
lf the class-name is specified the following fields are displayed.
Class Name
Class Type
L3 Proto
The name of an existing DiffServ policy, whose type must match the
interface direction. The command causes a service to create a reference
to the policy.
Enter the name of an existing DiffServ class.
The name of this class.
A class type of all means every match criterion defined for the class is
evaluated simultaneously and must all be true to indicate a class match.
The Layer 3 protocol for this class. Possible values are IPv4 and IPv6.
1180