ISO DIN HEAD UNIT PROVISION WITH POCKET
*
Note: Refer also to the instructions included with the aftermarket radio.
1
Align the holes in the ISO Snap-In
Backets with the holes in the head
unit and mount the brackets to the
head unit with the screws supplied
with the unit. (Figure A)
2
Slide the head unit/bracket assembly
into the radio opening until the side
clips engage. (Figure B)
3
Snap the ISO trimplate over the head
unit. (Figure C)
4
Snap the housing assembly into the
dash trim bezel. (Figure C)
NOTE: To remove the mounted head
unit, unclip and remove the ISO
Trimplate. Using a small flat blade
screwdriver, disengage the side clips
securing the ISO Snap In Brackets to
the housing/pocket assembly.
Continue to final assembly.
Assembled kit.
99-7860 KIT ASSEMBL Y
A
B
C