Page 2
99-7870 TABLE OF CONTENTS Dash Disassembly Honda Ridgeline 2005-2010 ......1 Kit Assembly ........2, 3, 4 Final Assembly .
Page 3
99-7870 HONDA RIDGELINE 2005-2010 Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip and remove entire panel sur- rounding radio and a/c control all the way over to left side of steering wheel. (Figure A) Remove (5) Phillips screws securing the radio and pocket assembly.
Page 4
99-7870 HONDA RIDGELINE 2005-2010 Attach the corresponding radio hous- ing bracket to the radio housing using the included carriage bolts and kep nuts. (Figure A) Position the factory pocket into the assembled radio housing assembly and secure with the factory hard- ware.
Page 5
99-7870 HONDA RIDGELINE 2005-2010 DIN HEAD UNIT PROVISION Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) Slide the aftermarket head unit into the cage and secure. (Figure B) KIT ASSEMBLY...
Page 6
99-7870 HONDA RIDGELINE 2005-2010 ISO DIN HEAD UNIT PROVISION Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A) Slide the head unit into the radio opening until the side clips engage. (Figure B) Snap the trim plate into the Radio Housing.
99-7870 FINAL ASSEMBLY 1 Locate the factory wiring harness in the dash and make the connection as shown. Metra recommends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation.