Using The Ip Filter Option - Ubee UBC1303 User Manual

Ubee Interactive
Label
Firewall Level
IPv4 Firewall
Protection
IPv6 Firewall
Protection
Firewall Options
Enable WAN
Blocking
Enable Dropping
Fragments
Allowed Services
Apply
6.4.3

Using the IP Filter Option

Use the IP Filter option to filter IP addresses to block Internet traffic to specific network
devices on the LAN. Any host on this list is not accessible to Internet traffic.
NOTE: You may also filter by the MAC address which does not require setting a static
lease. Refer to
To set up IP Filters:
1. Click Advanced Settings from the left side menu.
Ubee UBC1303AB00 Advanced Wireless Voice Gateway Subscriber User Guide • June 2017
Defines the level of IPv4 protection. Choices are Off, Low, Medium, High. Services are
based on the protection level and are displayed in the Allowed Services section.
Defines the level of IPv6 protection. Choices are On and Off. Services are based on the
protection level and are displayed in the Allowed Services section.
When enabled, WAN Blocking blocks PING access to the WAN public gateway IP address
that is exposed to the Internet. When disabled, PING access is allowed to occur, which is
necessary for the remote configuration of some VoIP phones (e.g. Cisco, Polycom, etc.).
When enabled, Dropping Fragments prevents all fragmented IP packets from passing
through the firewall.
Lists the allowed services based upon the selected firewall levels and options.
Saves changes.
Using the MAC Filter Option on page
Description
66.
Using the Advanced Settings Options
64