Using The Lan Options; Using The Dhcpv4 Option - Ubee UBC1303 User Manual

Docsis 3.1 advanced wireless voice gateway

Hide thumbs

Table Of Contents

100

101

Table of Contents

Ubee Interactive

Label

Operates the device as a Bridge device when enabled. Bridge Mode can only be enabled when

logged is an admin (vs. end user). Bridge Mode affects the entire device, meaning all networks

become bridged. Only the Status and Wireless menus are visible when in Bridge mode.

Bridge

Note: If you place a device in Bridge mode, and only one public IP address has been provisioned

mode

for the customer premises equipment (CPE), for example, a Home Router, consider disabling the

Wireless Primary Network SSID to avoid a wireless client inadvertently acquiring the single Public

IP address assigned via DHCP.

Operates the device in network address translation (NAT) mode when enabled. NAT mode is

selected by default and enables all gateway features of the UBC1303AB00. NAT mode is the default

operation mode when the device is reset to factory defaults.

NAT

NAT mode provides a wireless access point that allows sharing a single Internet connection.

mode

Enables Layer 3 IP protocol, DHCP for private IP address assignment, NAT for network address

and port translation, IP routing, firewall protection, and parental control features. Hint: All LAN and

wireless LAN interfaces are on the same Private IP subnet, and are translated to a single Public IP

address on the WAN gateway interface to the Internet.

Apply

Applies the selected operation mode.

6.2