Ubee UBC1303 User Manual page 54

Ubee Interactive
Label
The following fields are available for configuring the 2.4GHz and 5GHz radios.
Wireless
Network Name
(SSID)
Hidden SSID
802.11 mode
Ubee UBC1303AB00 Advanced Wireless Voice Gateway Subscriber User Guide • June 2017
Allows you to enable or disable the wireless radio. Both radios are enable by default.
Displays the wireless network name (SSID) to which client devices connect. It displays
the default SSID.
The default SSID for both the 2.4GHz and 5GHz radios is "name provided by cable
service provider" plus the last 4 characters of the Cable MAC address for both the
2.4GHz and 5GHz radios. The SSIDs are printed on the device label.
If you want to change the device SSID, highlight the current SSID as shown below.
Delete the default SSID and type in the name of your choice, then click Apply.
When enabled, the SSID is not visible to wireless clients unless it is manually set up on
the client. When disabled, the SSID is visible to wireless clients wishing to connect to
the UBC1303AB00.
Sets the wireless networking standard. Available modes for selection are:

2.4GHz: B/G/N-mix (default), G/N-mix, B/G-mix, and N-only

5GHz: A/N/AC-mix (default), N/AC-mix, AC-only, A-only, N-only
Description
Using the WLAN Option
48