Decimal Point; Rounding - Royal 482NT Operating Manual

DECIMAL POINT/ROUNDING
The DECIMAL-POINT is set by selecting tram the
foll~wing
4'
options:
.
~.. ,
Number Selection
(zero decimal point)
(one decimal point)
(two decimal point)
(three decimal point)
o
1
2
3
=
=
=
$X
$ X.X.
$ X.XX (U.S. Standard)
$ X.XXX
TO PROGRAM THE DECIMAL POINT
·PRG" + (DECIMAL POINT #) + (-%/RA)
1 digit #
Example: Program the Decimal Point for Option $X.XX (two decimal places, normally used in the United
States):
, . Tum ,the key to the ·PRG" (PROGRAM) position.
2. If a PRG/Z Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS
the (CHECK) Key, or if you did not program a PRG/Z Manager Password, go to Step 3.
3. TYPE (2), then PRESS the (-%/RA) Key. .
Important: In the "REG" (REGISTER) position it is not necessary to press the decimal paint when
ringing up a price.
ROUNDING is used to round
off
figures to the nearest whole numbers. Choose from the following 3 options
toselect the rounding as needed:
Number Selection
00
=
Rounds Numbers from.' - .4 to 0
50 ::.
Rounds Numbers from .5 - .9 to 1 (U.S. Standard)
99
=
Rounds Numbers from.' - .9 to 1
"PRG" + (ROUNDING #) + (CHARGE)
2 digit #
Example: Program Rounding to 50 (normally used in the United States):
1. Tum the key to the ·PRG" (PROGRAM) position.
2. It
a
PRG/Z Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS
the (CHECK) Key, or if you did not program a PRG/Z Manager Password. go to Step 3.
3. TYPE (50), then PRESS the (CHARGE) Key .
. .
Confirmation Report: The programming of the ROUNDING Is done in a non-print mode. To check your
results. a Program Confirmation Report is avaUabie. For details see Page 44.
22