Setting Voip Input/Output Level; Setting Voip Jitter Absorption Buffer - Kenwood TS-890S Setting Manual

3.2.4. Setting VoIP Input/Output level

There are settings for the input level and output level of VoIP in the KNS menu of the
TS-890S, but you use default values normally. Adjust the input level of the microphone
connected to the PC and the output level of the speaker, in the setting of the sound device of
the PC of the remote station. If it can not be adjusted with the PC, adjust with the KNS
menu of the TS-890S. For the operation method, refer to the operation manual of the
TS-890S.
Tips:
If the volume indicator is displayed on the recording device of the PC, adjust the microphone
input level of the PC so that the indicator shows about half to about 80% in the usual way of
speaking. After then, transmit the TS-890S in SSB mode. If the ALC meter display exceeds
the ALC zone, adjust the Audio Input Level (VoIP) of KNS Menu 4 so that it will not exceed
the ALC zone.

3.2.5. Setting VoIP Jitter Absorption Buffer

Adjust this item in the KNS menu of the TS-890S when there is a problem with the voice
quality of VoIP. Selecting a shorter time reduces the audio delay but noise is more likely to
occur due to missing audio packets or the like. Selecting a longer time increases the audio
delay but noise occurrence due to missing audio packets or the like is potentially reduced.
For the operation method, refer to the operation manual of the TS-890S.
Table 3.3 Setting the built-in VoIP
KNS Menu Item
3 Built-in VoIP
Table 3.4 Setting VoIP Input/Output level
KNS Menu Item
4 Audio Input Level (VoIP)
5 Audio Output Level (VoIP)
Table 3.5 Setting VoIP Jitter Absorption Buffer
KNS Menu Item
9