Remote Operation By Internet Connection; System Configuration / Feature Of Remote Control By Internet Connection - Kenwood TS-890S Setting Manual

21

4. Remote operation by Internet connection

4.1. System configuration / feature of remote control by Internet connection

Fig. 4.1: Remote operation by Internet connection
As shown in Figure 4.1, connect the TS-890S and the PC running ARCP-890 to the Internet
via the broadband router at each installation location.
The place where PC is installed is called the "Remote station". The place where TS-890S is
installed is called the "Host station".
Using the Internet, control command data communication and voice data communication
between TS-890S and ARCP-890 are performed. The voice data communication uses the
VoIP function built in TS-890S and ARCP-890, and you can listen to the received audio from
PC speaker. Audio input to the microphone of the PC can also be transmitted from the
TS-890S. (In this document, explains assuming that you will handle transmitted and
received audio at the remote station.)
It is also possible to display the band scope on ARCP-890. You can also use the band scope
with display speed equal to or higher than that of the TS-890S built-in scope.