Kenwood TS-890S Setting Manual page 69

Question
Even if you click the "Send" button on the
ARCP-890, it will not be modulated.
Transmitted voice and received voice become
larger or smaller, and it is not constant.
The last part of the voice transmitted from the
host station transceiver may be missing.
The sound of the transmission monitor cannot
be heard properly from the speaker of the PC
of the remote station.
■Comprehensive security software, etc.
Question
Although I use comprehensive security
software, when I attempt to connect with
KNS, the software displays a warning like
"Software is trying to connect to the
Internet", but I can press "Block" etc. ?
Answer
Refer to chapter "Setting TX Operation for use
in ARCP-890 and checking modulation line" in
this document and check the setting.
Audio input level of the TS-890S may be too
low. Refer to chapter "Setting of VoIP
Input/Output level" in this document and
adjust the input level.
Check whether the VoIP output device setting
of the ARHP-890 is correct.
Is the AGC turned on in the voice setting of
VoIP software?
For details, refer to the instruction manual of
VoIP software and confirm the setting.
If you perform an operation to return to
reception immediately after you finish talking
at the remote station, it may switch to
reception earlier than all the voice is
transmitted due to the delay of voice
transmission.
In this case, set the "Delay by TX to RX
Transition" time slightly longer at KNS
connection in the "Select Modulation Line"
from the ARCP-890 "TX/RX" menu
If you are using a VoIP software with
specifications that cannot be received during
sending voice, the sound of the transmission
monitor will not be heard properly.
Answer
Refer to the instruction manual of your
comprehensive security software and make
settings so that the port used by
communication in the ARCP-890, ARHP-890
and VoIP software is not blocked.
69