Kenwood TS-890S Setting Manual page 68

Question
Noise is mixed in the transmitted and received
sound.
Or, the transmitted / received sound is small,
where should I check and adjust?
Can I stop the beeps and the voice guidance
audio emitted by the transceiver?
Can I put the PC in sleep mode while not
using the host station (ARHP-890)?
If the host station (ARHP-890) is not used for
a certain period of time, the PC screen of the
host station disappears and it cannot respond
to the connection request from the remote
station.
If I make a connection request from the
remote station when the host station is not in
use, a message is displayed and I cannot
connect to the host station.
Answer
Refer to chapter "Setting of VoIP
Input/Output level" in this document and
adjust the audio input / output level.
The sound device driver may need to be
upgraded. Try checking for new versions and
upgrade the driver.
This may also depend on the specifications of
the sound device used in your PC. Try using
another sound card or USB sound device.
If you are building KNS with a conventional
system, refer to chapter "Setting beep mixed
output" in this document and set it to
"Received Audio Only".
When audio is input from the LAN connector
of the TS-890S, set beep volume and voice
guidance volume to 0.
It takes time to return from sleep mode.
Since the response to the remote station
cannot be returned until the timeout when
returning from the sleep mode, the host
station should not enter the sleep mode.
Is the power saving function of Windows
running and the power supply is not supplied
to the hard drive built in the PC of the host
station?
If the hard drive is powered off, the hard drive
will turn on to respond, but in this case the
response to the remote station cannot be
returned by timeout.
Therefore, do not turn OFF the power of the
hard drive in Windows power function setting.
68