Connection And Disconnection To Ts-890S; Setting Tx Operation For Use In Arcp-890 And Checking Modulation Line - Kenwood TS-890S Setting Manual

Select the speaker and microphone to use from the drop-down list.
Next, set "Voice quality" of "TS-890S Built-in VoIP". Select "High Quality Sound" for remote
control by LAN connection.
Next, set "fluctuation absorption buffer". Select "80 ms" for remote control by LAN
connection. Adjust this item when there is a problem with the voice quality of VoIP. Selecting
a shorter time reduces the audio delay but noise is more likely to occur due to missing audio
packets or the like. Selecting a longer time increases the audio delay but noise occurrence
due to missing audio packets or the like is potentially reduced. Set the value as small as
possible within a range that does not affect the operation.
After setting, click "OK" button and close "Configure VoIP" window.
Tips:
Depending on the OS used on the PC, clicking the "VoIP setting" button at the first start of
ARCP-890 may open a "Windows Security Alert" window. Click "Allow access" to advance the
setting.
(For details on this window display, see chapter "3.4.1. Windows Firewall Settings")

3.3.5. Connection and disconnection to TS-890S

When you click the "Connect" button in the main window of ARCP-890, the indicator will light
green and communication with the TS-890S will start. You can disconnect by clicking the
"Connect" button during connection.

3.3.6. Setting TX Operation for use in ARCP-890 and checking modulation line

Set whether the transmission operation from ARCP-890 corresponds to SEND/PTT operation
of the TS-890S or DATA SEND operation. In order to operate with the contents set in
TS-890S in the chapter "3.2.9. Configuration of the Input Path of TX Audio", set "DATA
SEND" for TX operation for use in ARCP-890.
When you are connected to the TS-890S and selecting "Select Modulation Line" from the
17