Setting The Delay By Tx To Rx Transition - Kenwood TS-890S Setting Manual

18
"TX/RX" menu of ARCP-890, the "Select Modulation Line" window will be displayed.
Fig. 3.8: "Select Modulation Line" window
As shown in the above figure, select "DATA SEND" for "TX Operation for use in ARCP-890".
For the setting of the modulation line, the contents set in TS-890S are displayed as they are
in the chapter "3.2.9. Configuration of the Input Path of TX Audio". As shown in the figure
above, when sending by DATA SEND (PF), make sure "LAN" is selected for audio input from
rear panel.
After setting and checking, click the "Close" button to close the window.

3.3.7. Setting the delay by TX to RX transition

When remote control is performed by LAN connection, the last part of the transmitted voice
may be interrupted at the end of transmission. This is due to delay in voice transmission by
VoIP.
In order to prevent this, it is possible to delay the timing of switching from transmission to