Setting Transmission Methods For Audio Input To The Acc2 Connector - Kenwood TS-990S Setting Manual

4.4. Setting Transmission Methods for Audio Input from the ACC2 Connector
The PTT of the microphone connected to the TS-990S, and the [SEND] key on
the TS-990S control panel, are the methods for transmitting audio input from
the microphone connected to the TS-990S. When TXing by these methods,
audio input as audio signals from the ACC2 connector cannot be transmitted.
To transmit audio input as audio signals from the ACC2 connector, select one of
the following methods.
● Transmitting using the ARCP-990
With the ARCP-990, settings must be performed to transmit audio input from
the ACC2 connector to use the on-screen [Send] button.
Select "Select Modulation Line" from the ARCP-990 "TX/RX" menu. The
"Select Modulation Line" window is displayed.
In this window, select "DATA SEND" under "TX Operation for use ARCP-990".
For details, refer to the ARCP-990 help.
● Transmitting using the PKS terminal in the ACC2 connector
Audio input from the ACC2 connector can be transmitted by setting the PKS
terminal in the ACC2 connector on the rear of the TS-990S to low.
For details of the connector and terminal specifications, refer to the TS-990S
instruction manual.
● Transmitting using the PF keys allocated to the DATA SEND function
If the DATA SEND function has been allocated to a PF key, operating the PF
key enables audio input from the ACC2 connector to be transmitted.
16