Table of Contents
Advertisement
This message is displayed
when the machine is in
embroidery mode, and the
character pattern
combination is too large to
fit in the embroidery frame.
This message is displayed
when the machine is in
embroidery mode and the
combined character
pattern is too large for the
embroidery frame. You can
rotate the pattern 90
degrees and continue
combining characters.
This message is displayed
when the machine is in
embroidery mode and the
embroidery unit tries to
initialize while the
embroidery frame is
attached.
This message is displayed
when the machine is ready
to embroider a pattern, and
the "Start/Stop" button is
pushed while the
embroidery frame is not
attached.
This message is displayed
when the machine is in
embroidery edit mode, and
you try to use an editing
function when the pattern is
not completely within the
red outline.
This message is displayed
when you try to save a
copyright protected pattern
to USB media or computer.
According to copyright
laws, patterns that are
illegal to reproduce or edit
cannot be saved to USB
media or computer. If this
message displays, save the
pattern in the machine's
memory.
This message is displayed
when the machine is in
embroidery mode and the
small frame is attached,
and the selected pattern
does not fit in the small
frame.
This message appears
when embroidery frame
(small) is attached while
aligning the embroidery
position using the built-in
camera.
ERROR MESSAGES
This message is displayed
when
is
pressed when changing
thread colors.
This message appears if
the machine is turned off
while embroidering, then
turned on again. Press
to return the
machine to the condition
(pattern position and
number of stitches) when it
was turned off. Follow the
procedure described in "If
the Thread Breaks During
Embroidering" on page 57
to align the needle position
and embroider the
remainder of the pattern.
This message is displayed
when the "Start/Stop"
button is pushed and the
machine is in embroidery
mode, but the embroidery
unit is not attached.
This message is displayed
when replacing the
embroidering bobbin
thread.
This message is displayed
when rotating a saved
combined pattern in the
Embroidery screen.
This message is displayed
when the embroidery frame
is attached.
193
5
Advertisement
Table of Contents
