Reprogramming A Button; Operating The Homelink; Erasing The Entire Homelink Memory (All Three Programs) - Lexus RX300 2003 Owner's Manual

Programming an entrance gate/Programming all devices
in the Canadian market
1. Decide which of the 3 HomeLink
program.
2. Place your hand–held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Press and hold the selected HomeLink
4. Continuously press and release (cycle) the hand–held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
a slow to a rapid flash after 20 seconds, you can release both
buttons.
6. Test the operation of the HomeLink
newly programmed button. Check to see if the gate/device
operates correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
button to program another device.
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
dealer for assistance.

Reprogramming a button

Individual HomeLink
R
buttons you want to to reprogram a single button, follow the procedure
"Programming the HomeLink
(b) Operating the HomeLink
R
.
To operate the HomeLink
R
in view while
HomeLink
HomeLink
R
HomeLink
button.
seconds as long as the button is pressed.
(c) Erasing the entire HomeLink
R
changes from
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
R
by pressing the
If you sell your vehicle, be sure to erase the programs stored
in the HomeLink
R
When programming the HomeLink
Transceiver, you may be operating a garage door or
other device. Make sure people and objects are out
of the way of the garage door or other device to
prevent potential harm or damage.
R
buttons cannot be erased, however,
R
".
R
, press the appropriate
R
button to activate the programmed device. The
R
indicator light should come on.
R
continues to send the signal for up to 20
(all three programs)
R
memory.
CAUTION
R
The
R
memory
R
Universal